What is the most important principle behind a hovercraft HC-111?
That's right! And 'aerodynamics. Although the HC-111 Hovercraft was destined to slip, especially in water, it acts more like an airplane. Yup, it's on the fan for this amphibious vehicle is fully functional and work!
If you want to build an HC-111 Hovercraft at your own, you need to know the most important principle. Building through the knowledge of these substances will not be difficult! And you know what? With easy to find equipment andsupplies such as plywood and a leaf blower, you can create your own, working full-HC-111 Hovercraft!
Just check the instructions below.
1 Get your sheet of plywood, then cut into 4 m diameter hard drive! You know the size of a manhole cover? Cut it!
2 Well, you now have a platform! To receive a stream of air power in your platform or leaf blower exhaust! Yup, it's possible anywhere in these materials. It 'true, one of these materials will serve as an airYour source for HC-111 Hovercraft!
3 Then, connect the air source, or you can drill a hole the size of the pipe.
4 Wrap the other side of the plywood with plastic sheeting.
5 Place the plastic cover at the center of the disk on plastic sheets! Then screw in the wood.
6 You see another side of the disc? Plastic clip to the edges in it!
7 After you attach, you can now carefully the edges with tape and clips! See if there is no airEscape from the band.
Now cut two 8-inch and 2 inches 6 circles carefully away from the center of the disc in plastic wrap.
9 Enter the source of air through the hole in the windshield! Yup, will air through the hole. Then the tape in place.
Voila, you have HC-111 Hovercraft accomplished! Drive it like you and another thing, you want to hold 160-200 pounds.
0 comments:
Post a Comment